Pandem / Rocket Bunny V2 LED Light-Kit DRL/Turn Signals (TRA Kyoto)

Description

Pandem / Rocket Bunny V2 LED Light-Kit DRL/Turn Signals (TRA Kyoto)

High quality LED Lighting Kit from Pandem Aero / Rocket Bunny (TRA Kyotot) in Japan!

The kit has 10 LEDs and functions as both DRL (Daytime Running Light) and turn signal indicators in the front.

The DRL light is in white colour and the turn signal is orange.

Control box (controller) included.

Developed for Pandem Aero / Rocket Bunny Widebody Kit bumpers of Version 2, for example for FR-S / BRZ, RX-7, 350Z, GT-R, S15 & NSX, but of course works as universal if you wish!

Basic wiring diagram:

Black (-) – Ground
Red (+) – 12V Voltage
Yellow – 12V ACC
White – 12V Positive feed for Headlights
Gray – 12V for Flashers / Warning Indicators
Brown – 12V Blinker Set A LED
Green – 12V Blinker Set B LED

Description:

With ACC in ON mode, the lighting will light in white colour. The corresponding LEDs will flash in orange with the turn signals turned on. With the parking light or headlights on, the LEDs will light orange. After the ignition is in the OFF position, it takes about 20 seconds for the LED lighting to turn off.

*Warning indicator function: If you connect the Gray wire to a positive feed, the LEDs will flash WHITE and ORANGE.

Technical specification:

Voltage: DC 9V-24 Volt
Power consumption: 0.7 Amps per unit
Waterproof: IP66

*NOTE, make sure all LEDs work properly before installation!

Detailed wiring diagram:

1.) Connect the controller (control box) to the LEDs.
2.) Connect the yellow wire to the positive feed from the battery and the black wire to the negative – the LEDs will now light up in white color.
3.) Connect the white wire to the positive feed of the battery – the LEDs will now light up in ORANGE color.
4.) Connect the brown or green cable to a 12 Volt source – Corresponding LED lights will now light up in ORANGE color.
5.) If you disconnect the yellow wire from 12 Volts, the LEDs will turn off after 20 seconds.
6.) If you connect the gray wire to 12 Volts while the LEDs are on, the lights will flash.