Lucas 1008cc Spridare 01D144x

Beskrivning

Siemens Deka Mototron 630cc FI114961 107961 Spridare

Denna Siemens Deka Mototron spridare flödar 630cc vid 3 bars bränsletryck. Den har 4 hålsteknik och är högohmig “Saturated”. Det är en “bosch standard” modell dvs den passar i dom flesta amerikanska och europeiska bilar.

Part # L107FM  (Siemens FI114961 – Mototron INJ-GAS-006 – Accel 74620L – MSD/Edge  2030 – 107961)
All tests run with n-Heptane (0.6855g/mL) @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar) (43.5PSI) , 14VDC (+/-0.05VDC), saturated driver. Engineering data specifies a flow ratio of apx. 1.035:1 when converting to gas.

Static Flow Rate: 60.56 lb/hr  = 668 cc/min = 458 g/min (+/-6%)
Dynamic Flow Rate 2.5ms PW @ 100Hz @ 600KPa: 19.5 mg/pulse (+/-6%)
Coil Resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers)
Gain: 0.11ms/mg
Offset: 0.055ms
Turn on time @ 14VDC: 1.14ms 
Turn off time: 0.85ms @ 600KPa
Spray Pattern: Cone (4-Hole)
Connector: Minitimer (Bosch EV1) 
Factory fitted with Viton upper and lower o-rings.
Note: Injector flow rates are based on testing with n-Heptane test solvent (0.6855 g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in most common injector designs at about a 3 to 4% higher rate than n-Heptane. A ratio of 1.035:1 can be used when converting the flow specifications above.