Description
Sinter plate for Volvo 240, 740, 940 With M90 gearbox 228mm
4-puck
Diameter: 228mm
Thickness: 8,1mm
Remember to compare the thickness with the original slat as the pressure plate often has to be shimmed about 1mm.
We have chimes for pressure plate, these are located under -Chims for pressure plate -
Note:
1. You have to shimm the pressure plate 1mm because the lamella is 1mm thicker than the original.
2. If you install the M90 box in another car (with e.g. M45-M46-M47 original) it is best to move the master cylinder to the clutch, otherwise the risk is that the master cylinder is larger in the car you install the box in and then it pushes the slave cylinder out so far that it touches the plate when fully disengaged and then the plate breaks.
Also remember to turn the flywheel clean, so that it has a new and 100% flat surface, otherwise it will not disengage as well.
-These points are very important-
Also keep in mind that the 940 with M90 has 240mm plate original (dual mass flywheel)

























