Description
Reinforced pressure plate
Model:
940 With M90 gearbox
Diameter: 240mm
Power/Performance: 530nm with original blade. +10% with sintered blade
-Remember that the protrusion on the lamella should be towards the engine-
Recommended slat thickness: 7,1mm
Keep in mind that many slats, even standard slats, are 8,1mm thick, so you have to trim 1mm.
Tip/Important:
This is the strongest pressure plate before going to 2-3 disc clutches
We always recommend using a steel braided hose or brake pipe to the clutch.
when the rubber hose flexes, see accessories
Also remember to turn the flywheel clean, so that it has a new and 100% flat surface.
(You can't just look at the flywheel and judge if it is flat, you have to measure/turn it)
Feel free to modify the ball to the clutch fork, so that it is adjustable from the outside, turn a ball with a threaded rod and thread it through the bursting cap
If you are installing an M90 gearbox on a car that does not have an M90 gearbox from the start, remember to also move the Master Cylinder.
We have also noticed that many standard lamellas are 8mm thick, like the sinter lamellas. Then you can add 1mm.
For street use, it is recommended to chime an additional 1mm, to disengage slightly easier.
CC42

























