Description
044 Replacement fuel pump
Max pressure 8bar
Flow at 3bar: 250l/h
Flow at 5bar: 200l/h
Connection in: M18x1,5
Connection out: M12x1,5 without check valve
M10x1,0 with check valve
We also have a full flow check valve for even higher capacity, see accessories.
The pump is enough for about 600hp with gasoline.
Also keep in mind that all petrol pumps are designed for petrol and will eventually break if you drive E85.
The only pumps that are designed for E85 are Walbro GST302, 400, 450, 520
Also remember not to tighten the nuts too tightly, as this could cause the connection to break.
The correct torque for is 3,7nm for the positive pole and 2,2nm for the negative pole.
NOTE: We recommend at least 12mm or AN10 hose on the suction side for these.
If you drive with less, the warranty will not apply!
If the car is going to stand over the winter, it is recommended that you run through the fuel system with, for example, Aspen Race Fuel, because today's gasoline contains very harmful substances, such as ethanol.

























