Lucas 166cc Spridare 621040

Beskrivning

Lucas 166cc 621040 Spridare

Denna Lucas spridare flödar 166cc vid 3 bars bränsletryck. Den har 3 hålsteknik och är högohmig 12,2 ohm “Saturated”. Det är en “bosch standard” modell dvs den passar i dom flesta amerikanska och europeiska bilar.

All tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC (+/-0.05VDC), saturated driver with RC cutoff.

Static Flow Rate: 15.1 lb/hr =  114.5 gm/min = 167 cc/min (+/-4%)
Dynamic Flow @ 2.5ms PW @ 100Hz: 3.34 mg/pulse  (+/-6%)
Coil Resistance: 12.2 Ohms (+/-0.35 Ohms) (This high-impedance injector will work with all factory ECM/PCM injector drivers)
Spray Pattern: Tri-Cone
Physical Dimensions: Bosch EV1 Style
Connector: Minitimer (Bosch EV1)
Factory fitted with Viton upper and lower o-rings. 
Grease supplied to lubricate o-rings prior to installation.

ADDITIONAL INFORMATION: 

Top feed disc injectors use a small disc with six holes around its circumference. The disc rests on a short chimney that surrounds a metering hole. As the disc is raised off the chimney by magnetic force, fuel flows through the holes in the disc, over the walls of the chimney, and out the metering hole to form a full, finely atomized cone.

Performance advantages over pintle injectors (i.e. Ford / Bosch & Accel types) as listed by Delphi:
The flat mating surface ensures that no excess fuel is present to evaporate and therefore, no deposits or clogging can occur.
Compatible with alternative fuels (i.e. E85, Methanol) 
Longer service life
High-speed disc action allows wider dynamic flow range for improved idling
Quieter operation
Revolutionary disc design resists build up deposits which can affect fuel flow.
No Fuel leakage for quicker starts